Influence of the deposition pressure on the properties of transparent conducting zirconium-doped zinc oxide films prepared by RF magnetron sputtering

Transparent and conducting zirconium-doped zinc oxide films with high transparency and relatively low resistivity have been successfully prepared by RF magnetron sputtering at room temperature. The deposition pressure was varied from 0.6 to 2.5 Pa. A transformation from a relatively compact structure to individual grains was observed with the increase of deposition pressure. As the deposition pressure increases, the resistivity increases sharply due to both, the decrease of hall mobility and carrier concentration. The lowest resistivity achieved was 2.07 10 3 V cm at a deposition pressure of 0.6 Pa with a hall mobility of 16 cm2 V 1 s 1 and a carrier concentration of 1.95 1020 cm 3. The films are polycrystalline with a hexagonal structure and a preferred orientation along the c-axis. All the films present a high transmittance of above 90% in the visible range. The optical band gap decreases from 3.35 to 3.20 eV as the deposition pressure increases from 0.6 to 2.5 Pa