Adsorption of azacrown ethers at solid–liquid interface. Contact angle and neutron reflectivity study

Adsorption of two alkylated N,N′-diaza-18-crown-6 ethers (decyl- and hexadecyl-derivatives, ACE-10 and ACE-16, respectively) on solid surfaces was studied by using contact angle and neutron reflectivity measurements. The solid substrates used were (a) Si covered with a native oxide layer (Si/SiO2) and (b) Si with sputtered Pt layer (Si/Pt). The sensitivity of neutron reflectivity was drastically improved by applying the intermediate Pt layer of 150 Å, which gave rise to several Kiessig fringes in the experimentally accessible q-range. The position of the fringes is very sensitive to slight changes of the interfacial composition induced by adsorption of a thin monolayer, otherwise very difficult to detect. Unfortunately, in the studied case this sensitivity is immediately lost due to undesired adsorption of a protonated material on the Pt surface exposed to the lab air. A decrease of surface energy (increase of contact angle) of both Si/SiO2 and Si/Pt upon exposure to toluene solutions of ACEs suggests that the latter are attached to the surface via the hydrophilic azacrown ether head with alkyl chains standing upright towards the liquid phase.