Oxidation of nickel base alloys strengthened by different hardening effects

Three nickel base alloys strengthened by different hardening effects were investigated by thermogravimetry in air under isothermal conditions. The alloys investigated were (gamma)ʹ-Ni3 (Al, Ti)-hardening alloy 80A (75Ni, 21Cr, 2·5Al, 1·7Ti, DIN No. 2·4952),solid solution hardened alloy C22 (59Ni, 21Cr, 13Mo, 3·5 Fe, 2·8W, DIN No. 2·4602) and a new high nitrogen containing and nitride hardening alloy N (61Ni, 27Cr, 10W, 1·4Ti, 0.2N). Tests were conducted in air between 900 and 1100° C for 48 h. Parabolic oxidationrates were determined and the formation of the oxide layer was investigated by optical microscopy and SEM. Oxidation data showed that the hardening mechanism has almost no influence on the oxidation kinetics. All of the alloys investigated formed chromia layers. After initial transient stateoxidation, the kinetics followed a parabolic law. Alloy 80A had the highest oxidation rate of the investigated alloys, which is attributed first to its lower chromium content and second to the formation of chromium carbides. At grain boundaries, internal oxidation, mainly of aluminium andtitanium, took place. The Al and Ti contents of alloy 80A were too low for the formation of a protective inner oxide layer of one of the two elements to take place. Alloy C22 showed the best resistance to oxidation since its chromium content of 21% is close to that for the minimum in the kineticsof oxide formation that has been found for binary Ni–Cr alloys. Additionally, there were no chromium rich precipitates to shift this chromium content to values that would result in higher oxidation rates. The nitride-containing alloy N contained a higher chromium content of 26%, whichled to a higher oxidation rate than that for alloy C22. A certain amount of inner oxidation took place, especially at coarse Cr2N precipitates. Conclusions are presented about the optimised chemical composition of chromia laye-forming nickel base alloys for minimised oxidationrate.