Ultrasound assisted mercury extraction from soil and sediment Original Research Article

A method for mercury (Hg) determination in soil, river sediment and marine sediment without sample digestion is investigated. Mercury determination is performed by cold vapour atomic absorption spectrometry (CV-AAS) using a flow injection system. Mercury quantitatively leaches out from the investigated marine sediment into 30% (v/v) HNO3 assisted by ultrasonic irradiation (during 90–120 s) when sample particles size are ≤120 μm. Similar conditions can be applied for Hg determination in river sediment and soil, excepting the time of sonication which needs to be increased to 180 s and KCl is also added to the extraction medium. The presence of 0.15% (m/v) KCl in addition to 30% (v/v) HNO3 is seen to be effective for quantitative Hg leaching. The certified samples PACS-2 and MESS-3 (both marine sediment from NRCC), Buffalo River (NIST 8704), Montana Soil (NIST 2710) and the non-certified river sediment sample RS-3 were analysed. The attained results were well within the 95% confidence level of the certificate or close to information value. Samples were analysed using aqueous standard calibration. A characteristic mass of 25 pg, a LOD (3s) of 0.2 μg Hg l−1 and a LOQ (10s) of 0.012 μg Hg g−1 are typically attained. These are based on 800 μl of sample solution and 1.000 g of sample mass in 20 ml. The RSD of 10 consecutive runs of the sample is <5%. The proposed method was finally applied for the determination of Hg in real samples of soil, river sediment and marine sediment. The same samples were also analysed using a digestion method giving similar results.