Simultaneous mixture analysis by using non-linear spectrophotometric data and linear iterative target transformation factor analysis Original Research Article

Non-linear absorption spectral data obtained from ternary mixtures of analytes are analyzed by using a linear model, iterative target transformation factor analysis (ITTFA). The use of transformed original variables is used to correct non-linearities in the original data. Absorbance below a certain limit (k) is described as linear and above this limit as non-linear. The extension of the regressor variables is the squared absorbances above the linear range. The variation of the prediction error as a function of the number of the factors and the k-values were considered and the minimum prediction error was evaluated for reaching to optimum. Except the natural non-negativity constraint the correlation constraint also is used on concentration vector in each iteration of ITTFA algorithm. The reliability of the method is evaluated using model data for ternary mixtures by spectral overlapping and different degrees of non-linearity. Simultaneous spectrophotometric determination of Eu3+, UO22+ and Th4+ with arsenazo III as chromogenic reagent is used as experimental model systems with non-linearity behavior of Eu3+and UO22+ components. The application to both synthetic and real data sets with different degrees of non-linearity demonstrate the ability of the proposed methodology to obtain better results than original data and ITTFA. The relative standard errors of prediction for proposed method in comparison with using the PLS calibration on original and extended data are nearly smaller.