Optimization of operating conditions of axially and radially viewed plasmas for the determination of trace element concentrations from ultrasound-assisted digests of soil samples contaminated by lead pellets Original Research Article

The method of ultrasound-assisted extraction followed by inductively coupled plasma optical emission spectrometry (ICP-OES) used for the determination of trace element concentrations (arsenic, copper, lead, antimony, and zinc) in shooting range areas was optimized. Optimization was achieved not only on the basis of the analysis of appropriate standard reference materials but also on that of 31 synthetic mixtures of matrix and analyte elements (aluminum, antimony, arsenic, calcium, copper, lead, iron, manganese, silicon, and zinc), in five concentrations. All the measurements were performed in robust plasma conditions which were tested by measuring the Mg II 280.270 nm/Mg I 285.213 nm line intensity ratio. The highest Mg II 280.270 nm/Mg I 285.213 nm line intensity ratios were observed when a nebulizer gas flow of 0.8 L min−1, auxiliary gas flow of 0.2 L min−1 and plasma power of 1400 W were used for both the axially and radially viewed plasmas. The analysis of 31 synthetic mixtures of the selected elements showed that As concentrations could be accurately determined with axially viewed plasma alone. The determination of Pb and Sb could be performed with either axially or radially viewed plasma whereas, surprisingly, Cu could be determined with high accuracy using radial plasma alone with a power of 1400 W. All the elements investigated were determined with high accuracy using robust plasma conditions and a combination of axially and radially viewed plasmas. The total recoveries of elements from SRM 2710 (Montana soil) and SRM 2782 (Industrial sludge) were highly comparable to leach recoveries certified by the National Institute of Standards and Technology (NIST).