Separation of chelating agents as copper complexes by capillary zone electrophoresis using quaternary ammonium bromides as additives in N-methylformamide Original Research Article

This study presents the use of quaternary ammonium bromides as additives in N-methylformamide (NMF) for the separation and quantification of chelating agents as copper complexes by capillary zone electrophoresis (CZE). The new quaternary ammonium bromides were synthesized in our laboratory and used for the first time for CZE applications performed in NMF media. The methods were developed and optimized for determination of six chelating agents (trans-1,2-diaminocyclohexane-N,N,N′,N′-tetraacetic acid (CDTA), diethylenetriaminepentaacetic acid (DTPA), ethylenediaminetetraacetic acid (EDTA), N-(2-hydroxyethyl)ethylenediamine-N,N′,N′-triacetic acid (HEDTA), nitrilotriacetic acid (NTA) and triethylenetetraaminehexaacetic acid (TTHA)) as copper complexes. Among the tested electrolyte additives in NMF media (pHapp 10.2) dimethyldioctylammonium bromide (DMDOAB), dimethyldinonylammonium bromide (DMDNAB) and dimethyldidecylammonium bromide (DMDDAB), at a concentration of 20 mmol L−1 improved the separation of the copper complexes. The optimized methods require only 12 min for one analysis, and the detection limits for copper complexes of DMDNAB, the best-performing additive, were ≤24 μmol L−1. Relative standard deviations (R.S.D.) for migration times were ≤2.5, ≤2.1, ≤3.1% and for peak areas, ≤3.1, ≤3.0, ≤3.2% for DMDOAB, DMDNAB and DMDDAB used as additives, respectively. All three methods were successfully applied to the analysis of natural and wastewater samples. No matrix effects from these samples were observed. The interaction between quaternary ammonium bromides and copper complexes is discussed.