Heat-treated Saccharomyces cerevisiae for antimony speciation and antimony(III) preconcentration in water samples Original Research Article

An analytical method was developed for antimony speciation and antimony(III) preconcentration in water samples. The method is based on the selective retention of Sb(III) by modified Saccharomyces cerevisiae in the presence of Sb(V). Heat, caustic and solvent pretreatments of the biomass were investigated to improve the kinetics and thermodynamics of Sb(III) uptake process at room temperature. Heating for 30 min at 80 °C was defined as the optimal treatment. Antimony accumulation by the cells was independent of pH (5–10) and ionic strength (0.01–0.1 mol L−1). 140 mg of yeast and 2 h of contact were necessary to ensure quantitative sequestration of Sb(III) up to 750 μg L−1. In these conditions, Sb(V) was not retained. Sb(V) was quantified in sorption supernatant by inductively coupled plasma mass spectrometry (ICP-MS) or inductively coupled plasma optical emission spectrometry (ICP-OES). Sb(III) was determined after elution with 40 mmol L−1 thioglycolic acid at pH 10. A preconcentration factor close to nine was achieved for Sb(III) when 100 mL of sample was processed. After preconcentration, the detection limits for Sb(III) and Sb(V) were 2 and 5 ng L−1, respectively, using ICP-MS, 7 and 0.9 μg L−1 using ICP-OES. The proposed method was successfully applied to the determination of Sb(III) and Sb(V) in spiked river and mineral water samples. The relative standard deviations (n = 3) were in the 2–5% range at the tenth μg L−1 level and less than 10% at the lowest Sb(III) and Sb(V) tested concentration (0.1 μg L−1). Corrected recoveries were in all cases close to 100%.