Microstructures and improved wear resistance of 3D needled C/SiC composites with graphite filler

Three-dimensional (3D) needled carbon/carbon (C/C) composites with a lowest porosity of 15.6% were achieved after 1 cycle of impregnation by phenolic resin slurry containing graphite filler, hot-pressing curing and pyrolysis. Carbon/silicon carbide (C/SiC) composites were obtained by liquid silicon infiltrating C/C composites. The aim was to incorporate cost effectiveness and excellent performance of C/SiC braking material. Using filler content not exceeding 30 wt% in the slurry promised undamaged C/C segments in C/SiC composites. The linear wear rate of C/SiC using 30 wt% filler was 0.33 μm side−1 cycle−1 and displayed a fourfold decrease; its weight wear rate was 2.46 mg side−1 cycle−1 and minus 171%, compared with the previously reported values of C/SiC without filler, at a braking velocity of 28 m/s. Its friction coefficients and friction stability coefficients appeared relative insensitive to changes in braking velocities and displayed higher values at high braking velocities compared with the previous values.