Title of article :
Contribution of Ti addition to characteristics of extruded Cu40Zn brass alloy prepared by powder metallurgy
Author/Authors :
Shufeng Li، نويسنده , , Hisashi Imai، نويسنده , , Haruhiko Atsumi، نويسنده , , Katsuyoshi Kondoh، نويسنده ,
Issue Information :
ماهنامه با شماره پیاپی سال 2011
Pages :
6
From page :
192
To page :
197
Abstract :
The aim of this paper was to investigate the properties of Cu40ZnTi for the purpose of developing a new high-strength, lead-free brass by powder metallurgy. The effect of Ti addition on precipitation hardening behavior of Cu40Zn (denoted as BS40) brass was studied with respect to mechanical properties and microstructures. BS40 and Cu40Zn − 1.0 wt.%Ti (denoted as BS40-A) brass powders were prepared by water atomization process, and β phase was retained in the raw powders predominately. The BS40 powder and Ti powder were elementally mixed to prepare Cu40Zn + 0.5 wt.%Ti (denoted as BS40-B) and Cu40Zn + 1.0 wt.%Ti (denoted as BS40-C) premixed powders. The alloy powders and premixed powders were solidified at 1053 K for 600 s by spark plasma sintering (SPS) and extruded subsequently. It was observed that Cu2ZnTi intermetallic compound (IMC) and CuZnTi metastable phase resulted from the reaction between Ti and CuZn showed distinct grain refinement effect on extruded Cu40Zn brass. Thus, the excellent strengthening effect processes by precipitation hardening and deform working was obtained, which responding to an yield strength of 345 MPa, and a ultimate tensile strength of 597 MPa, showed 65.9% and 30.4% higher than that of extruded Cu40Zn brass, respectively.
Keywords :
Brass , Spark plasma sintering , Precipitation hardening
Journal title :
Materials and Design
Serial Year :
2011
Journal title :
Materials and Design
Record number :
1069336
Link To Document :
بازگشت