A critical comparison of various data processing methods in simple uni-axial compression testing

The paper compares the error associated with various data processing methods to obtain true stress–plastic strain data from the load–deformation curves generated from uni-axial compression tests. Towards this end, uni-axial compression tests have been conducted on three representative materials viz. modified 9Cr–1Mo ferritic steels, alloy D9 (a titanium modified austenitic stainless steel) and 316L(N) austenitic stainless steel in wide ranges of temperatures and strain rates. It has been observed that the absolute average error associated with maximum true plastic strain calculation in all the three materials is always more than 5% and sometimes as high as 42.1% if the elastic region is removed either from the load–stroke curve or engineering stress–strain curve to get the true stress–plastic strain curve. However, the absolute average error associated with plastic strain calculation is always less than 5% if the elastic region is removed from the true stress–strain curve.