Effective in situ material properties of micron-sized SiO2 particles in SiO2 particulate polymer composites

Several analytical models exist for determination of the Young’s modulus and coefficient of thermal expansion (CTE) of particulate composites. However, it is necessary to provide accurate material properties of the particles as input data to such analytical models in order to precisely predict the composite’s properties, particularly at high particle loading fractions. In fact, the constituent’s size scale often presents a technical challenge to accurately measure the particles’ properties such as Young’s modulus or CTE. Moreover, the in situ material properties of particles may not be the same as the corresponding bulk properties when the particles are embedded in a polymer matrix. To have a better understanding of the material properties and provide useful insight and design guidelines for particulate composites, the concept of “effective in situ constituent properties” and an indirect method were employed in this study. This approach allows for the indirect determination of the particle’s in situ material properties by combining the experimentally determined composite and matrix properties and finite element (FE) models for predicting the corresponding composite properties, then backing out the effective in situ particle properties. The proposed approach was demonstrated with micron-size SiO2 particle reinforced epoxy composites over a range of particle loading fractions up to 35 vol.% by indirectly determining both the effective Young’s modulus and the effective CTE of the particles. To the best of our knowledge, this study is the first published report on the indirect determination of both the Young’s modulus and the CTE of micron size particles in particulate composites. Similar results on Young’s modulus of micron-size SiO2 particles measured from nano-indentation testing are encouraging.