Prediction of the maximum heat transfer capability of two-phase heat spreaders – Experimental validation

The present paper is devoted to an experimental study to determine the thermal behaviour of a two-phase heat spreader (TPHS) with micro-grooves. The proposed application is the cooling of fuel cell systems. This TPHS aims at reducing the volume of actual cooling systems and to homogenize the temperature in the hearth of fuel cells. The TPHS is flat with a wide evaporating area (190 × 90 mm2) compared to the condenser area (30 × 90 mm2). It has been tested with three working fluids: water, methanol and n-pentane. Experimental results obtained with methanol show a temperature difference lower than 1.6 K on the entire evaporator area for a heat transfer rate equal to 85 W and a working temperature equal to 70 °C. The TPHS has been tested in both horizontal and vertical favourable orientation (thermosyphon orientation). The temperature field is similar in both cases for heat transfer rates lower than 155 W. In horizontal orientation, a confocal microscope is used to measure the meniscus curvature radius along the grooves. A two-phase flow model allowing the calculation of the meniscus radius, the liquid and vapour pressures and the liquid and vapour velocities along the TPHS is developed. The comparison between experimental and model results shows the good ability of the numerical model to predict the meniscus curvature radii from which the maximum heat transfer capability of the TPHS is depending.