Wear behaviour of some low alloyed steels under combined impact/abrasion contact conditions

The wear behaviour of some low alloyed steels has been investigated using a laboratory impeller–tumbler wear test equipment in which the steel samples are worn by angular granite particles under combined impact/abrasion wear contact conditions. The wear of the steels was evaluated by weight loss of the steel samples while the wear mechanisms of the steels were investigated by post-test light optical microscopy (LOM), scanning electron microscopy and energy dispersive X-ray analysis. The worn steel surfaces display a very rough surface topography with pronounced craters and distinct grooves caused by high and low angle impacts, i.e. abrasive wear, respectively. Besides, fragments of embedded granite particles are frequently observed in the worn surface of the steels. The wear of the steels tends to decrease with increasing steel hardness. However, instead of using the bulk hardness value the hardness of the worn/plastically deformed surface layer should be used when modelling the wear resistance. Further, the wear resistance of the steels was found to be dependent on the microstructure and chemical composition. Steels with similar type of microstructure show a linear decrease in weight loss with decreasing grain size and increasing carbon content.