Micro-contact based modelling of abrasive wear

A model that describes the abrasive wear between a hard and rough surface and a softer and smooth surface is developed. The contact between these two solids is modelled based on micro-contacts [M.A. Masen, M.B. de Rooij, Abrasive wear between rough surfaces in deep drawing, in: Proceedings of the 6th Austrib Tribology Conference, Perth, Australia, 2002, pp. 601–608], instead of the more conventional summits-based modelling [; ]. Using 3D surface roughness measurements, the hardness of both surfaces and process parameters as applied load, a collection of micro-contact spots is identified and subsequently the surface to surface approach is calculated. The micro-contact spots act as abrasive entities, resulting in wear of the softer contact partner. On a pin-on-disk tribometer the abrasive action of a single micro-contact, or asperity, at different loads is experimentally investigated. An expression for the severity of wear as a function of the indentation depth is obtained by applying a curve-fit through experimentally obtained data. When the indentation depth of a micro-contact spot into the counter surface, as well as the material properties are known, the wear caused by a single micro-contact is obtained. The macroscopic wear volume is found by summing the volumetric wear of each individual micro-contact.