A new method to investigate the sliding wear behaviour of materials based on energy dissipation: W–25 wt%Cu composite

A new method is proposed to explain and monitor wear behaviour based on energy dissipation. The wear of a W–25 wt%Cu composite against 52100 steel was used to demonstrate this approach with pin-on-disc tests conducted under three normal loads. An energy-dependent criterion, namely, specific wear volume (wear volume/dissipated energy (mm3/J)), was defined to evaluate the wear of the composite. The specific wear volume can be used as a substitute for the traditional wear rate due to the simultaneous expression of several wear parameters and because of its strong dependence on the wear mode. The specific wear volume appears to be constant in any particular “wear mode” regardless of the active “wear processes”. In the wear of this composite, processes such as particle pull-out, mechanically mixed layer (MML) formation, crack propagation and delamination were observed. But, combination of these processes in each test had identical specific wear volumes. Thus, all of these wear processes were considered to be consecutive stages of the same wear mode: fatigue wear. The amount of dissipated energy and the volumetric loss increased with increasing normal load. Also, changing the normal load changed the rate of energy dissipation per unit sliding distance.