Characterization of pore distribution in activated carbon fibers by microbeam small angle X-ray scattering Original Research Article

In the present work, the results corresponding to the first experiments done with single activated carbon fibers (ACFs) at the microfocus beamline (ID13) in the ‘European Synchrotron Radiation Facility’ (Grenoble) are presented. The experiments done with CO2 and steam ACFs have demonstrated the suitability of this technique to characterize a single ACF. The experiments show that scattering intensity increases with the burn-off degree, which agrees with SAXS experiments carried out using bigger amounts of fibers. Moreover, the two-dimensional scattering patterns show that, in this type of ACFs, the porosity development during the activation process is isotropic. In addition, it has been demonstrated that the use of an X-ray microbeam of 2 μm diameter allows the characterization of different regions of the same fiber with microscopic position resolution. The scans across the fiber diameter are the first direct proof for the previous results obtained by our research group. Thus, in the case of CO2 ACFs, the scattering is high in different regions across the fiber diameter, confirming that CO2 activation takes place within the fibers, generating a quite homogeneous development of porosity. On the other hand, in the case of steam ACFs, the scattering is much higher in the external zones of the fibers than in the bulk, which means that steam focuses the activation in the outer parts of the fibers.