Microstructural analysis of in situ mesophase transformation in the fabrication of carbon–carbon composites Original Research Article

In this work, we examined the microstructures formed during the pyrolysis of naphthalene mixed with AlCl3 catalyst, in the critical temperature range of 300–500 °C and at varying pressures. In addition, non-rigidized preforms were densified by multiple cycle in situ transformation and compared the process with impregnation using fully transformed AR mesophase pitch under similar conditions. The process of mesophase formation in the bulk phase and within tightly packed fiber bundles was observed to be similar: spherule nucleation from the isotropic phase, coalescence of spherules forming bulk mesophase, and mesophase flow before hardening. The hardened mesophase displays the coarse, fibrous, and lamellar microstructure observed in needle cokes. The molten naphthalene was observed to evenly penetrate in-depth the large void spaces and fiber bundles. After two in situ cycles, the fiber bundles and the inter-fiber bundle regions were well filled with transformed mesophase. The incremental filling of the larger void spaces reduced the calculated filling efficiencies from 47% in the first cycle to below 15% in the third through fifth cycle. An 8% improvement in densification efficiencies was achieved by applying modest pressures during the pyrolysis. The extent of mesophase penetration with AR mesophase was observed to decrease from the outer to the inner regions of the preform. The results suggest impregnation with naphthalene catalyst mixture is efficient in filling tightly packed fiber bundles but not large void spaces. Multiple cycles are required in order to fill the large void spaces.