Improved interfacial mechanical properties of Al2O3-13wt%TiO2 plasma-sprayed coatings derived from nanocrystalline powders Original Research Article

The interfacial toughness of two types of Al2O3-13wt%TiO2 plasma-sprayed ceramic coatings on steel substrates—“conventional” and “nano”—has been measured using the Rockwell indentation method. The interfacial toughness of the “conventional” coating and the “nano” coating is found to be 22 and 45 J.m−2, respectively. The “conventional” coating, which was prepared using a fused feedstock powder available commercially, has a microstructure consisting primarily of fully-molten (FM) and solidified “splats”. The feedstock powder for the “nano” coating comprised reconstituted agglomerates of nanocrystalline Al2O3 and TiO2 powders. The microstructure of the “nano” coating, as characterized using scanning and transmission electron microscopy techniques, consists of regions of FM “splats” interspersed with partially-molten (PM) rounded microstructural features. The substructure in these PM features (20–50 μm diameter) consists of α-Al2O3 grains (0.5–1 μm) surrounded by a TiO2-rich amorphous phase. The FM/steel interfaces in both the “conventional” and the “nano” coatings are found to be cracked (before mechanical testing), whereas the PM/steel interfaces in the “nano” coating are found to be adherent. It is believed that the unique bimodal microstructure, together with the presence of the TiO2-rich amorphous phase at the PM/steel interface, is responsible for the significantly improved interfacial toughness of the “nano” coating. The key differences in the failure modes in the two types coatings are also discussed, with reference to a simple model.