Title of article :
Microstructure and fatigue behavior of cold spray coated Al5052 Original Research Article
Author/Authors :
R. Ghelichi، نويسنده , , D. MacDonald، نويسنده , , S. Bagherifard، نويسنده , , H. Jahed، نويسنده , , M. Guagliano، نويسنده , , B. Jodoin، نويسنده ,
Issue Information :
دوهفته نامه با شماره پیاپی سال 2012
Pages :
7
From page :
6555
To page :
6561
Abstract :
The effect of cold spray coating in inducing residual stresses in the substrate and its effect on delaying crack initiation under cyclic loading have been studied on Al5052 alloy specimens. Different sets of Al5052 specimens have been coated with pure Al and Al7075 feedstock powder, using a low-pressure cold spray coating technique. Some sets of specimens were grit blasted (GB) before coating. The microstructural evolution of the substrate after coating and the fatigue behavior of the coated structure have been studied. In order to obtain the fatigue S–N diagram for each set, as-received and coated specimens with and without preceding GB treatment have been tested in a load-controlled condition. X-ray diffraction has been used to measure the residual stresses both in the deposited materials and the substrates. The results are discussed to highlight the effect of this emerging surface treatment on the characteristics of the treated material. Compressive residual stresses, which led to appreciable increase in the fatigue life, have been observed in all the coated sets. The results indicate that the fatigue strength was significantly improved up to 30% in the case of Al7075 coatings. The results show a strong dependency of the fatigue strength on the deposited material and the spray parameters.
Keywords :
Cold spray coating , Fatigue strength , Residual stress , Aluminum alloys
Journal title :
ACTA Materialia
Serial Year :
2012
Journal title :
ACTA Materialia
Record number :
1146618
Link To Document :
بازگشت