Water uptake and its impact on the texture of lentils (Lens culinaris) Original Research Article

Water uptake behavior of three cultivars of lentils (Boomer, French-green and Nugget) was studied at three different hydration temperature regimes (room temperature, 50 °C and 85 °C). Boomer had the highest amount of water uptake capacity (74.60 g water/100 g of seeds) at room temperature (20 °C) which can be linked with its pore properties. French-green lentils imbibed the largest amount of water at elevated soaking temperatures (50 °C and 85 °C) and can be attributed to its higher seed surface area to volume ratio, high protein content and relatively thinner seed coat. Water uptake at elevated temperatures (50 °C and 85 °C) were predicted by a two parameter Mitscherlich model (R2 > 0.99, χ2 < 0.5) within 1.36–3.07% average absolute error. At room temperature, only the water uptake of Boomer was reasonably predicted by this model. The texture (hardness) of the soaked lentils was found to be related the amount of water uptake and soaking temperature used rather than seed size or seed mass alone. The hardness values of Boomer, French-green and Nugget at 85 °C after 75 min soaking were reduced to 5.66%, 3.53% and 6.77%, respectively compared to their respective initial seed hardness values. The water uptake capacity of the aged Boomer was found to be significantly reduced compared to the fresh seeds (p < 0.01) while French-green and Nugget do not exhibit significant change (p < 0.05). During 72 h of germination, hardness of all lentil cultivars showed a typical pattern which decreased in the first 24 h followed by an increase compared to the hydrated seeds. A peak hardness value was obtained within 36–48 h before finally declining in all types of lentils. Structural changes within the cotyledon, such as depletion of starch granules, new nuclei formation and development of tissues in vascular bundles and rupture of the seed coat were observed during germination.