Micro-mould fabrication for a micro-gear via vacuum casting

A micro-mould fabrication method based on vacuum casting was developed and its functionality and reproducibility were demonstrated. The micro-components used in this study were SU-8 photoresist micro-gears fabricated by UV photolithography. These micro-gears served as the master patterns from which silicone rubber micro-mould cavities were fabricated with the use of the vacuum casting technology. The process parameters that had an influence on the quality of the micro-mould cavities were identified and optimised. Using the optimised process parameters resulted in high fidelity silicone rubber micro-mould cavities at high resolutions. Dimensional analysis was carried out using white light interferometry. It was found that all the micro-gear cavities in the micro-moulds were dimensionally accurate and consistent to the master gear, with a dimension deviation less than 3% of the respective dimensions. Micro-casting was also carried out using the silicone rubber moulds. Micro-gears were successfully transferred from the silicone rubber moulds into PU resin and wax pieces under vacuum conditions, thereby demonstrating that the micro-mould fabricated was capable of producing functional micro-parts that were able to replicate micro-features.