Modification of surface finish produced by hard turning using superfinishing and burnishing operations

In this study the surface finish produced by hard turning of a 41Cr4 low-alloy steel quenched to about 60 HRC hardness, using mixed Al2O3–TiC ceramic inserts, was subsequently modified by superfinishing and multipass burnishing operations. In the case of hard turning surfaces were produced by conventional and Wiper cutting tool inserts. The main goal of this study was to examine how additional abrasive and non-removal technological operations change 2D and 3D roughness parameters and enhance service properties of the machined surfaces. It was documented that both superfinishing and burnishing operations allow to obtain smoother surfaces with lower surface roughness and better bearing characteristics.