Thermal and rheological characteristics of CuO–Base oil nanofluid flow inside a circular tube

In the present experimental investigation, stable CuO–Base oil nanofluids with different particle weight fractions of 0.2% to 2% are prepared. Then, these fluids are used for heat transfer measurements as well as rheological behavior investigation. Density, thermal conductivities, viscosities and specific heat capacities of base fluid and all nanofluids at different temperatures are measured and the effect of nanoparticles concentration on fluid properties is investigated. Also, heat transfer characteristics of CuO–Base oil nanofluids laminar flow in a smooth tube under constant heat flux are studied experimentally. Experimental results clearly indicate that addition of nanoparticles into the base fluid enhances the thermal conductivity of the fluid and the enhancement increases with increasing of particle concentration. For the particle concentrations tested, nanofluids exhibit Newtonian behavior. It is observed that the dynamic viscosity substantially increases with the increase in nanoparticle concentration and this increase is more pronounced at the lower temperatures of the nanofluid. The specific heat capacity of nanofluids is significantly less than that of base fluid and it is decreased with the increase in nanofluid concentration. The results show that for a specific nanoparticle concentration, there is an increase in heat transfer coefficient of nanofluid flow compared to pure oil flow. A maximum increase of 12.7% in Heat Transfer coefficient was observed for 2 wt.% nanofluid at the highest Reynolds number studied in this investigation. Furthermore, heat transfer coefficients obtained using experimental fluid properties are compared to those obtained using the existing theoretical models for fluid properties.