Improvement of surface wettability and interfacial adhesion ability of poly(p-phenylene benzobisoxazole) (PBO) fiber by incorporation of 2,5-dihydroxyterephthalic acid (DHTA)

By introducing 2,5-dihydroxyterephthalic acid (DHTA) into poly(p-phenylene benzoxazole) (PBO) macromolecular chains, dihydroxy poly(p-phenylene benzobisoxazole) (DHPBO) was synthesized and then DHPBO fibers were prepared by dry-jet wet-spinning method. Effects of hydroxyl polar groups on surface wettability and interfacial adhesion ability of PBO fiber were investigated. With the incorporation of double hydroxyl polar groups, contact angle on PBO fiber for water can decrease from 71.4° to 50.70°, and contact angle for ethanol can decrease from 37.2° to 27.40°. The wetting time on DHPBO fibers for water can be as short as 650 ms, which is half of that of PBO fibers. The interfacial shearing strength (IFSS) between DHPBO (10% mol content DHTA) fibers and epoxy resin is 18.87 MPa, 92.55% higher than that of PBO fibers. SEM images indicate that the PBO/epoxy composite failure mode may change from fiber/matrix adhesive failure to partially cohesive failure.