Dynamic behavior of an aggregate material at simultaneous high pressure and strain rate: SHPB triaxial tests

Low velocity impacts on energetic materials induce plastic deformations and sliding friction which can lead to ignition. If some ignition criteria have been proposed, the remaining difficulty is to characterize the mechanical behavior of the material when submitted to the corresponding solicitations (high pressure and high strain rate). Thus, a technique based on the Split Hopkinson Pressure Bars system is proposed to carry out a triaxial compression test. A cylindrical specimen is placed into a confining ring and is compressed by the system of bars. The ring prevents the radial extension of the specimen and creates a lateral confining pressure. The material and dimensions chosen for the ring maintain a constant radial pressure during the test. Some tests were carried out on an inert aggregate material and proved the validity of this experimental device. The experimental data processing shows the influence of both the pressure and the strain rate. The shear stresses, which contribute to thermal dissipation and then to the ignition threshold, increase according to the pressure.