Catalytic oxidation of alkenes by manganese(III) porphyrin-encapsulated Al, V, Si-mesoporous molecular sieves

Cationic manganese-porphyrin, [meso-tetrakis(4-trimethylammoniophenyl)porphyrinato]manganese(III) pentachloride (MnTAPP), has been prepared and encapsulated into mesoporous molecular sieves Al-MCM-41 and V-MCM-41, containing different amounts of Al and V, respectively. The catalytic activities of these heterogeneous materials were tested in the liquid phase oxidation of cyclohexene and styrene in acetonitrile with iodosylbenzene (PhIO) as oxygen source. Both types of catalysts were active in the oxidation reaction. MnTAPP encapsulated in Al-MCM-41 produces allylic oxidation products alone and no epoxide with styrene was found. However, it produces both epoxide and allylic oxidation products with cyclohexene. At the same time, MnTAPP encapsulated in V-MCM-41 produces epoxide as major product and little allylic oxidation product with styrene, while both epoxide and allylic oxidation products were obtained with cyclohexene. It is suggested that the regioselective effect is due to relatively more acidic Al-MCM-41 than V-MCM-41 which could make the Cdouble bond; length as m-dashC bond unreactive towards epoxidation and produces allylic oxidation product. With increasing Al or V content in the support, the porphyrin loading was found to increase, which in turn increases the catalytic activity of the heterogeneous systems. The heterogeneous catalysts were reused for three times. The selectivity of these heterogeneous catalysts does not change appreciably even after three times of reusing, but their catalytic activity decreases marginally. This may be attributed to catalyst leaching and/or decomposition of MnTAPP complex under the reaction conditions.