The impact of the nitridation process on the properties of the Si–SiO2 interface

A newly developed technique for the simultaneous measurement of the oxide–silicon interface properties and of minority carrier lifetime in the silicon volume was used for a systematic study of the nitridation process of oxide films.This technique is based on the surface recombination velocity measurements, and does not require the formation of a capacitor structure, so it is suitable for the measurement of as-grown interface properties. Oxides grown both in dry and in wet environments were prepared, and nitridation processes in N2O and in NO were compared to N2 annealing processes. The effect of nitridation temperature and duration were also studied, and processes of rapid thermal oxidation (RTO) and nitridation (RTN) were compared to conventional furnace nitridation processes. Surface recombination velocity was correlated with nitrogen concentration at the oxide–silicon interface obtained by secondary ion mass spectroscopy (SIMS) measurements. Surface recombination velocity (hence surface state density) decreases with increasing nitrogen pile-up at the oxide–silicon interface, indicating that in nitrided interfaces surface state density is limited by nitridation. NO treatments are much more effective than N2O treatments in the formation of a nitrogen–rich interface layer and, as a consequence, in interface state reduction. X-ray photoelectron spectrometry (XPS) analyses were used to extend our correlation to very thin oxides (3 nm).