Effect of finishing methods on surface roughness and color stability in all-ceramic systems

The objectives of the study were to evaluate the effect of the finishing methods on the surface roughness, and to investigate changes in CIE L*a*b* color coordinates of all-ceramic systems after different finishing methods and accelerated aging. Sixty specimens were prepared, 20 specimens each for Vitadur-N, IPS Empress II, and Cerec Vita Block Mark II. The surface roughness (Ra) following treatment with the different finishing methods was measured using a profilometer. Surface examinations in all groups were made by using a scanning electronic microscope. CIE L*a*b* values of the specimens were determined. After all specimens were subjected to accelerated aging, color measurements were repeated, and the total color differences (ΔE) were calculated. Data were analyzed statistically. Significant differences in surface roughness among all-ceramics were found (P < 0.05). No significant differences were found between the surface roughness of the glazed and polished all-ceramics (P > 0.05). After accelerated aging, all groups had acceptable color changes (ΔE < 2).