The effect of water on the behaviour of alumina–paraffin suspensions for low-pressure injection moulding (LPIM)

The properties of ceramic powder–paraffin suspensions for low-pressure injection moulding (LPIM) is of critical importance to the successful production of high quality ceramic parts. Due to the high hygroscopicity of fine alumina powder, water introduced into the suspension at any stage of the production prior to sintering, may significantly influence its rheological behaviour and hence determine the process parameters as well as the properties of the sintered ceramics. In the industrial environment humidity cannot easily be avoided. Its effect is usually detrimental — it causes flocculation, which is usually the source of defects in sintered ceramics. However, according to the results of the present work, the effect can also be put to good use. Penetration of water into the as-moulded green parts facilitates binder removal and prevents defect formation during this processing step.