Influence of the processing route of porcelain/Ti–6Al–4V interfaces on shear bond strength

This study aims at evaluating the two-fold effect of initial surface conditions and dental porcelain-to-Ti–6Al–4V alloy joining processing route on the shear bond strength. Porcelain-to-Ti–6Al–4V samples were processed by conventional furnace firing (porcelain-fused-to-metal) and hot pressing. Prior to the processing, Ti–6Al–4V cylinders were prepared by three different surface treatments: polishing, alumina or silica blasting. Within the firing process, polished and alumina blasted samples were subjected to two different cooling rates: air cooling and a slower cooling rate (65 °C/min). Metal/porcelain bond strength was evaluated by shear bond test. The data were analyzed using one-way ANOVA followed by Tuckeyʹs test (p<0.05). Before and after shear bond tests, metallic surfaces and metal/ceramic interfaces were examined by Field Emission Gun Scanning Electron Microscope (FEG-SEM) equipped with Energy Dispersive X-Ray Spectroscopy (EDS). Shear bond strength values of the porcelain-to-Ti–6Al–4V alloy interfaces ranged from 27.1±8.9 MPa for porcelain fused to polished samples up to 134.0±43.4 MPa for porcelain fused to alumina blasted samples. According to the statistical analysis, no significant difference were found on the shear bond strength values for different cooling rates. Processing method was statistically significant only for the polished samples, and airborne particle abrasion was statistically significant only for the fired samples. The type of the blasting material did not cause a statistically significant difference on the shear bond strength values. Shear bond strength of dental porcelain to Ti–6Al–4V alloys can be significantly improved from controlled conditions of surface treatments and processing methods.