Sinter forging of rapidly quenched eutectic Al2O3–ZrO2(Y2O3)-glass powders

Spray dried agglomerates of Al2O3–ZrO2 (1% Y2O3) with 4 wt.% borosilicate glass were arc plasma sprayed and rapidly quenched into water. Because of the rapid quenching the particles <25 μm were mostly amorphous. After annealing 1 h at 1200 °C the scale of the microstructure of the particles was on the order 30 nm. Hot forging of this powder yielded dense specimens with the width of the ZrO2 phase still less than 100 nm. Since the particle size ranged from 5 to 25 μm and the scale of the particle microstructure was <100 nm, densification was controlled by creep of the particles rather than by the typical hot pressing mechanism of diffusion along the neck between particles to fill the pores. Thus, the scale of the microstructure controls densification rather than the particle size. These powders offer an alternate source for manufacturing nanostructured parts and should be more suitable for hot pressing or forging than nanoparticulate powders.