CO2 gasification rate analysis of coal char in entrained flow coal gasifier

Coal chars of four coal types were gasified with carbon dioxide using a PDTF or TGA at high temperature and pressure. Test conditions of temperature and partial pressure of the gasifying agent were determined to simulate the conditions in air-blown or oxygen-blown entrained flow coal gasifiers. Coal chars were produced by rapid pyrolysis of pulverized bituminous coals using a DTF with a nitrogen gas flow at 1670 K. In gasification tests with the PDTF, gasification temperatures were 1670 K or below and partial pressures of carbon dioxide were 0.7 MPa or below. Carbon monoxide of 0.6 MPa or below was supplied for the gasification tests with the TGA. esult, coal types showed a large difference in the char gasification rate with carbon dioxide, and this difference remained large without decreasing even in the high-temperature area when the gasification rate was controlled by pore diffusion the same as in entrained flow gasifiers. Inhibition of the gasification reaction by carbon monoxide was also observed. Reaction rate equations of both the nth order and Langmuir–Hinshelwood type were applied to the char gasification reaction with the random pore model and the effectiveness factor, and the applicability of these rate equations to air-blown and oxygen-blown entrained flow gasifiers evaluated. Gasification rate equations and kinetic parameters applicable to a pore diffusion zone at high temperature were obtained for each coal.