Effect of different surfactants on methane hydrate formation rate, stability and storage capacity

The effects of anionic surfactants sodium dodecyl sulfate (SDS) and linear alkyl benzene sulfonate (LABS), cationic surfactant cetyl trimethyl ammonium bromide (CTAB) and non-ionic surfactant ethoxylated nonylphenol (ENP) on the formation, dissociation and storage capacity of methane hydrate have been investigated. Each surfactant was tested with 3 concentrations 300, 500 and 1000 ppm and it has been found that SDS, when prepared with these three concentrations speeds up the hydrate formation rate effectively. LABS increases the hydrate formation rate at 500 and 1000 ppm but decreases it at 300 ppm. CTAB and ENP have promotion effect on hydrate formation rate at 1000 ppm but decrease it at 300 and 500 ppm. Hydrate stability tests have been performed at three temperatures 268.2, 270.2 and 272.2 K with and without surfactant promoters. The results show that all tested additives increase the dissociation rate of methane hydrate below the ice point. CTAB has the minimum and LABS the maximum effect on the methane hydrate dissociation rate. Experimental results on hydrate gas content revealed that maximum storage capacity of 165 V/V is obtained with 1000 ppm of CTAB in water.