Preparation and rheology of biochar, lignite char and coal slurry fuels

Slurries of an Oil Mallee biomass char, a low rank coal char and sub-bituminous coals were prepared by mixing the finely milled solids with water and a range of additives including polyacrylic acid, charged copolymers D101 and D102, and sucrose. The resultant slurries were subjected to rheological characterizations including apparent viscosity and yield stress. The effect of the solid type, particle size distribution, and the additives on preparation of highly loaded slurries with the desired rheological behaviour were systematically examined in terms of apparent viscosity and yield stress. The additives D101 and D102 were found to be most effective in producing highly loaded suspensions with a low apparent viscosity and yield stress. Particle size distributions were manipulated to improve the solid loading. Suspensions produced by powder mixture containing equal weight precent of 30 min and 1 min milled powders gave a broad size distribution and is very effective in increasing the solid loading in slurries. The significant improvement in the solid loading was shown to be achieved by (i) increasing particle packing density via size distribution control and (ii) minimising the strength and number of the interactions between colloidal particles. The maximum solid loading of flowable (or relatively low apparent viscosity) slurries achieved with the Oil Mallee char is ∼40 wt.%, with the sub-bituminous coals 56–63 wt.%, and with the lignite char ∼65 wt.%. This study has shown that for low rank coals such as lignite, thermal and densification treatment is essential to achieve the solid loading of slurry fuel.