Title of article
Microstructure and properties of titanium aluminides on Ti6Al4V titanium alloy produced by chemical vapor deposition method
Author/Authors
Sitek، نويسنده , , R. and Kaminski، نويسنده , , J. and Borysiuk، نويسنده , , J. and Matysiak، نويسنده , , H. and Kubiak، نويسنده , , K. and Kurzydlowski، نويسنده , , K.J.، نويسنده ,
Issue Information
روزنامه با شماره پیاپی سال 2013
Pages
9
From page
36
To page
44
Abstract
Microstructure, phase composition, and properties of the titanium aluminide diffusion layers produced on Ti6Al4V by Chemical Vapour Deposition (CVD) at various process parameters were investigated. It was found that the layers produced by CVD contain a mixture of the Ti2AlN + TiAl2+Ti3Al phases, while the additional heat treatment step after CVD changes the composition of the layers into the TiN + Ti2AlN + TiAl + Ti3Al mixture. The layers are characterized by high hardness of about 800 HV0.05 after CVD aluminizing and about 850 HV0.05 after CVD aluminizing followed by heat treatment, and by good adhesion to the substrate. Their corrosion resistance is only slightly lower than that of the Ti6Al4V alloy substrate and is fully adequate to a wide range of applications.
Keywords
C. Coatings , D. Microstructure , intermetallic and otherwise , transmission , B. Surface properties , A. Titanium aluminides , based on Ti3Al , F. Electron microscopy
Journal title
Intermetallics
Serial Year
2013
Journal title
Intermetallics
Record number
1505628
Link To Document