Characterization of a peptide affinity support that binds selectively to staphylococcal enterotoxin B

The influences of mass transfer and adsorption–desorption kinetics on the binding of staphylococcal enterotoxin B (SEB) to an affinity resin with the peptide ligand, Tyr-Tyr-Trp-Leu-His-His (YYWLHH) have been studied. The bed and particle porosities, the axial dispersion coefficient and the pore diffusivity were measured using pulse experiments under unretained conditions. Adsorption isotherms for SEB on YYWLHH resins with peptide densities in the range from 6 to 220 μmol/g were measured and fitted to a bi-Langmuir equation. At peptide densities below 9 μmol/g and above 50 μmol/g, dissociation constants were lower (2 × 10−3 to 7 × 10−3 mol/m3), and binding capacities were larger (43–47 mg SEB/g). In the range from 9 to 50 μmol/g dissociation constants were larger (13 × 10−3 to 24 × 10−3 mol/m3) and capacities were lower (33–37 mg SEB/g). These observations are consistent with a transition from single point attachment of the protein to the ligand at low peptide densities to multipoint attachment at high peptide densities. The general rate (GR) model of chromatography was used to fit experimental breakthrough curves under retained conditions to determine the intrinsic rate constants for adsorption, which varied from 0.13 to 0.50 m3 mol−1 s−1, and exhibited no clear trend with increasing peptide density. An analysis of the number of transfer units for the various mass transfer steps in the column indicated that film mass transfer, pore diffusion (POR) and the kinetics of adsorption can all play an important role in the overall rate of adsorption, with the intrinsic adsorption step apparently being the rate determining step at peptide densities below 50 μmol/g.