Determination of lignin by size exclusion chromatography using multi angle laser light scattering

A method was developed using high-performance size exclusion liquid chromatography (HPSEC) with multi-angle laser light scattering (MALLS), quasi-elastic light scattering (QELS), interferometric refractometry (RI) and UV detection to characterize and monitor lignin. The combination proved very effective at tracking changes in molecular conformation of lignin molecules over time; i.e. changes in molecular weight distribution, radius of gyration, and hydrodynamic radius. Until this study, UV detection (280 nm) had been the primary lignin determination method for chromatography. Three different HPLC columns were used to study the effects of pH, flow conditions, and mobile phase compositions (dimethyl sulphoxide, water, 0.1 M NaOH, and lithium bromide) on the chromatography of lignin. Since light scattering accuracy is highly dependent on solute concentration, both the UV and RI detectors were calibrated for use as concentration detectors. Shodex Asahipak GS-320 HQ column with 0.1 M NaOH (pH 12.0) run at 0.5 ml/min was found to give the highest separation and most consistent recovery. The study also revealed that the lignin aggregated at pH below 8.5. This aggregation was detected only by MALLS and was not observed on UV or RI detectors. It is very important to take this loss in apparent concentration due to aggregation into consideration before collecting reliable depolymerization data.