Title of article :
Oxide thickness-dependent transient cladding hoop stress
Author/Authors :
Kim، نويسنده , , Kyu-Tae and Jerng، نويسنده , , Dong Wook، نويسنده ,
Issue Information :
روزنامه با شماره پیاپی سال 2011
Abstract :
A few thrice-burned Zry-4 fuel assemblies which were loaded in one of the PWRs operating in Korea were found to be failed due to PCI during a power ramp following a rector trip, while thrice-burned Zr–Nb fuel assemblies and twice-burned Zry-4 ones were intact. To investigate the effect of fuel rod oxide thickness on power ramp-induced cladding hoop stress, three intact fuel rods were selected, which include an intact twice-burned Zry-4 fuel rod, an intact thrice-burned Zr-4 fuel rod and an intact thrice-burned Zr–Nb fuel rod. With the use of a fuel performance analysis code, burnup-dependent steady-state cladding stress and ramp power-dependent cladding stresses at the power-ramped burnup were predicted for the three intact fuel rods. It was found that the cladding oxide thickness has a considerable effect on the ramp power-dependent cladding hoop stresses. In addition, the cladding maximum stress of the thrice-burned Zry-4 fuel rod with 125 μm oxide thickness exceeded an ultimate cladding tensile strength of the Zry-4 cladding when the pellet–clad friction coefficient-dependent cladding stress concentration ratio was considered. However, the thrice-burned Zr–Nb fuel rod with 50 μm oxide thickness was evaluated to have a considerable margin against the power ramp-induced PCI failure.
Journal title :
Nuclear Engineering and Design Eslah
Journal title :
Nuclear Engineering and Design Eslah