Slate flexural and anchorage strength considerations in cladding design

This paper describes an experimental investigation on the flexural and anchorage strength of slate for cladding. The study has been conducted on sawed slate specimens, all showing the same surface finishing. Slate flexural strength was compared for two distinct situations: (i) using a 3-Point flexure loading configuration in batches of materials with larger cross-sectional specimen dimension (50 × 30 mm2); and (ii) using a 4-Point flexure loading configuration in the same batch of materials but with smaller cross-sectional dimensions (30 × 25 mm2). The 4-Point bending specimens were tested in three different directions considering slate anisotropy planes. Load was applied along the direction perpendicular to the planes of schistosity; and also along two directions parallel to the planes of schistosity. Slate anchorage strength has been determined on slate slabs with 400 × 200 × 30 mm3 with dowel anchorage in 8 mm diameter cylindrical holes with 35 mm depth. Test load was applied perpendicularly to the schistosity planes. Cladding stone in building facades and its supporting systems must be compatible with the behaviour and performance of other interfacing systems, such as curtain walls and superstructure frames. In this sense, a properly executed dimensional stone cladding should be designed and installed within the capabilities and limitations of the slate’s support system to resist all active forces or actions. The results of this work reveal the importance of complementary characterization techniques for dimension stone cladding, particularly for anisotropic rocks as slates. From the results it is possible to conclude that schistosity planes have an utter influence on either anchorage or flexural strength.