Multivariate optimisation of hydride generation procedures for single element determinations of As, Cd, Sb and Se in natural waters by electrothermal atomic absorption spectrometry

Continuous flow hydride generation procedures for As(III), total inorganic As, Cd, total inorganic Sb, Se(IV) and total inorganic Se from sea and hot-spring water samples were optimised by experimental designs. Ir-coated graphite tubes were used as preconcentration and atomisation medium of the hydrides generated. Several factors affecting the hydride generation efficiency were studied. Results obtained from Plackett–Burman designs suggest that sodium borohydride flow rate and reduction coil length, are significant factors for total inorganic arsenic hydride generation. For cadmium hydride generation the significant factors are hydrochloric acid concentration, hydrochloric acid and sodium borohydride flow rates and reduction coil length. For total inorganic antimony hydride generation the factors affecting the hydride generation procedure are hydrochloric acid and potassium iodide concentrations and reduction coil length; finally, pre-reduction coil length and oven temperature for the pre-reduction step are statistically significant factors for total inorganic selenium hydride generation. In addition, the factors studied for the arsenic and selenium hydride generation from As(III) and Se(IV) are not significant. From these studies, the significant variables were optimised by central composite designs. Validation carried out analysis on three reference materials: SLRS-4 (Riverie water), CASS-3 (seawater) and NIST-1643d.