A novel rapid method for preparation of sample solution for chemical characterisation of titanium minerals by atomic spectrometry

A new rapid decomposition and dissolution method with a mixture of sodium di-hydrogen orthophosphate and di-sodium hydrogen orthophosphate as a novel flux is described. The minerals are fused with (1:1) mixture of the above salts (flux) and the melt is dissolved in distilled water. The solution is diluted to desired volume depending on the instrumental technique used for determination. ICP-OES is used for the determination of Al, Ca, Mg, Cr, V, Si, Fe and Ti without interference from titanium, iron and sodium phosphate (introduced as flux). All the elements except Si and V are also determined by AAS. The use of nitrous oxide–acetylene flame eliminates the depression due to titanium in the measurement of Mg, Mn, Cr and Fe in air–acetylene flame. Synthetic mixture conforming to ilmenite and rutile composition are analyzed by ICP-OES and AAS to check the validity of the method. The results are in good agreement. The proposed method has been applied to natural samples and the results are evaluated against the established decomposition method using potassium bisulphate. Both ICP-OES and AAS yielded comparable results. The R.S.D. of the proposed method in case of ICP-OES varies from 0.5 to 2%, whereas for AAS it varies from 1.5 to 3% for different elements (n = 5). The novelty of the proposed sample decomposition lies in its simplicity, ease and speed of fusion with minimal skills besides being eco-friendly unlike the reported tedious complicated decomposition procedures involving variety of fluxes and lot of hazardous chemicals.