Partial oxidation of methane with air for synthesis gas production in a multistage gliding arc discharge system

Conventional catalytic processes of CH 4 conversion to produce synthesis gas require both high temperatures and high pressure. Non-thermal plasma is considered to be a promising technology for the synthesis gas production from methane since it can operate in ambient conditions. In this study, a multistage gliding arc discharge system was employed to investigate the effects of stage number, feed gas composition, feed flow rate, frequency, applied voltage, and electrode gap distance on the CH 4 and O 2 conversions and the product distribution. The studied system consisted of four units of gliding arc discharge reactors connected in series, and the plasma generated across the gliding arc electrodes was AC current with different voltages and frequencies. In this study, air was used for the partial oxidation of methane. The results showed that increasing stage number, voltage, or electrode gap distance enhanced both CH 4 and O 2 conversions in contrast with the effects of increasing CH 4 / O 2 molar ratio, feed flow rate, and frequency. The optimum conditions were found at a CH 4 / O 2 molar ratio of 3/1, a feed flow rate of 150 cm 3 /min, and a frequency of 300 Hz for the maximum conversions of CH 4 and O 2 with a high synthesis gas selectivity and a very low energy consumption. The energy consumption of the gliding arc discharge system was found to be low, about 2.45 × 10 - 18 – 2.96 × 10 - 18 W s (15.3– 18.5 eV )/molecule of CH 4 converted as compared to 3.36 × 10 - 18 W s (21 eV)/molecule of CH 4 converted for the corona discharge system with pin and plate electrodes.