Fast liquid chromatography-diode array detection assisted by chemometrics for quantification of seven ultraviolet filters in effluent wastewater

A fast chromatographic method is presented for simultaneous quantification of seven organic ultraviolet (UV) filters (benzophenone-3,4-methylbenzilidene camphor, octocrylene, 1-(4-tert-butylphenyl)-3-(4-methyoxyphenyl)1,3-propanedione), ethylhexyl methoxy cinnamate, ethylhexyl salicylate and homosalate) in effluent wastewater samples. The UV filters were pre-concentrated by Bond Elut-ENV cartridges and separated on an ODS column (15 cm × 0.46 cm, 5 μm) in less than 2.5 min using a non-aqueous mobile phase of methanol–acetonitrile (50:50, v/v) with flow-rate of 1.5 mL min−1. Appropriate baseline correction through asymmetric least squares was applied to reduce the matrix of background signals in three way data. Then, second-order calibration based on multivariate curve resolution-alternating least squares (MCR-ALS) was implemented on the unfolded three-way data obtained from liquid chromatography with diode array detection (LC-DAD) through standard addition calibration method for handling co-eluted peaks, systematic and proportional errors. Recoveries ranging from 76% to 130% and %RSD values less than 11.2 for all UV filter shows the accuracy and precision of the proposed method in wastewater samples. In addition, statistical t-test as well as computed elliptical joint confidence region (EJCR) confirms the accuracy of the proposed method and indicates the absence of both constant and proportional errors in the predicted concentrations. This study demonstrates that coupling of the fast HPLC-DAD method with powerful algorithm of MCR-ALS can be considered as an efficient method for quantification of UV filters in highly contaminated samples of wastewaters where both time and cost per each analysis can be reduced significantly.