Thermodynamic analyses of adsorption-enhanced steam reforming of glycerol for hydrogen production

A non-stoichiometric thermodynamic analysis is performed on the adsorption-enhanced steam reforming of glycerol for hydrogen production based on the principle of minimising the Gibbs free energy. The effects of temperature (600–1000 K), pressure (1–4 bar), water to glycerol feed ratio (3:1–12:1), percentage of CO2 adsorption (0–99%) and molar ratio of carrier gas to feed reactants (1:1–5:1) on the reforming reactions and carbon formation are examined. The results show that the use of a CO2 adsorbent enhances glycerol conversion to hydrogen and the maximum number of moles of hydrogen produced per mole of glycerol can be increased from 6 to 7 due to the CO2 adsorption. The analyses suggest that the most favourable temperature for steam–glycerol reforming is between 800 and 850 K in the presence of a CO2 adsorbent, which is about 100 K lower than that for reforming without CO2 adsorption. Although high pressures are favourable for CO2 adsorption, a lower operating pressure gives a higher overall hydrogen conversion. The most favourable water to glycerol feed ratio is found to be ∼9.0 above which the benefit becomes marginal. Carbon formation could occur at low water to glycerol feed ratios, and the use of a CO2 adsorbent can suppress the formation reaction and substantially reduce the lower limit of the water to glycerol feed ratio for carbon formation.