Optimizing phase imaging via dynamic force curves

Tapping mode (TM, also called intermittent contact mode) atomic force microscopy (AFM) has been routinely used in many laboratories. However, consistent or deliberate control of measuring conditions and interpretation of results are often difficult. In this article, we demonstrate how measurement parameters (drive frequency, cantilever stiffness and oscillation amplitude) affect the tapping tipʹs state. This has been done by systematic dynamic force measurements performed on mica and polystyrene surfaces together with computer simulations. Our study shows the following results. (1) Weaker cantilevers, smaller amplitude and higher drive frequency (around the resonance) lead to an extension of the attractive region (greater phase lag) in amplitude–phase–distance curves and thus can help to achieve stable high-setpoint TM imaging with minimal tip–sample pressure. (2) Bistability of tapping tips often exists and may cause height artefacts if the setpoint falls in the bistable region. (3) Tapping tips with high vibrating energy (stiff cantilevers and large amplitude) driven at resonance are only slightly perturbed by tip–sample interactions and usually remain monostable during the sweep of the scanner position. This can help to achieve good phase contrast without significant artefacts when the setpoint falls in a continuous negative–positive phase shift transition region. (4) Low energy cantilevers (compliant cantilevers and small amplitude) usually result in large phase shift and can be used to acquire large phase contrast images. However, height artefacts will occur when the setpoint falls in the bistable region usually existing for such cantilevers. (5) Computer simulations are useful in understanding the bistability in dynamic force curves and determining either material properties or the optimal imaging parameters.