Iron oxide thin film growth on Al2O3/NiAl(1 1 0)

The electronic structure and the growth morphology of iron oxide thin films were studied by means of Synchrotron Radiation Photoelectron Spectroscopy (SRPES) and Low Energy Electron Diffraction (LEED). A thin well-ordered alumina film on a NiAl(1 1 0) single crystal surface as a template for iron oxide growth was employed. Two different methods of iron oxide film preparation were applied. In the first attempt, iron deposited at room temperature was subsequently annealed in oxygen. Even though a whole layer of iron was oxidized, an expected long-range order was not achieved. The second attempt was to perform reactive deposition. For this reason iron was evaporated in oxygen ambient at elevated substrate temperature. This method turned out to be more efficient. Diffused but clear LEED patterns of six-fold symmetry indicating hexagonal surface atoms arrangement were observed. From the PES measurements, binding energies for Fe2p for grown iron oxide film were established as well as energy distribution curves for the valence band. Growth curves based on Fe3p core-level peak intensities for iron and iron oxide were plotted identifying type of film growth for both deposition methods. Based upon these results we have found evidence for interdiffusion in the interface between alumina and iron oxide at the early stages of growth. Further deposition led to formation of Fe3O4(1 1 1) (magnetite) overlayer. Moreover, the quality of the film could also be improved by long-time annealing at temperatures not exceeding 575 K. Higher annealing temperature caused disappearance of LEED pattern indicating loss of long-range ordering.