Self-association of hyperbranched poly(sulfone-amine) in water: studies with pyrene-fluorescence probe and fluorescence label

Both pyrene-fluorescence probe and fluorescence label techniques are used to investigate the association behaviors of hyperbranched poly(sulfone-amine) (HPSA) in aqueous solution. In the presence of HPSA, excimer emission peak evidently appeared, while no excimer peak was observed in the emission spectra in the absence of HPSA. The excitation spectrum monitored at excimer emission red shifts by about 38–40 nm compared to that monitored at monomer emission, which shows that the excimer is formed by preassociated pyrene chromophores. In the same concentration of pyrene, monomer emission of pyrene decreases but excimer emission increases with increasing the concentration of HPSA; the ratio of excimer-to-monomer emission intensity (IE/IM) gradually increases, reaches a critical point at 5–7 g/l, and sharply increases with the concentration. Pyrene-labeled hyperbranched poly(sulfone-amine) (Py-HPSA) was synthesized from 4-(1-Pyrene)butyroyl chloride and HPSA. The monomer emission and excimer emission of Py-HPSA show the concentration-quenching effect, while IE/IM increases monotonously, approaches a critical point, and then suddenly increases with increasing the concentration of Py-HPSA. Influences of acidity and solvents on the fluorescence emission were studied. In high concentrations of hyperbranched polymer, pH and DMSO significantly influence the emission of pyrene, and excimer peak disappears at 72% of DMSO fraction.