Micro-solid oxide fuel cell using thick-film ceria

A fabrication method that does not use lithography or etching processes for thick-film based micro-SOFCs (Solid Oxide Fuel Cells) was described and discussed. In this study, a new type of micro-SOFC was fabricated using a free-standing thick-film electrolyte with ~ 20 μm thickness. This structure has the advantages of both electrolyte-support and electrode-support type SOFCs. Generally, the electrolyte should be thicker than e.g., ~ 150 μm since a thinner electrolyte easily cracks in a self-supporting mode during the fabrication procedure. Thus, a new mounting method was developed in order to use a thin-electrolyte film. In this study, a ~ 20 μm-thick GDC (Gd-doped ceria) electrolyte film was successfully mounted on a ~ 400 μm-thick GDC ring by sintering these two pieces together. Ni-GDC and Sm0.5Sr0.5CoO3 were brush painted as an anode and a cathode, respectively. With this new configuration, it was possible to construct an electrolyte-supported SOFC using a thick-film ceria-based electrolyte and measure the power density. The open-circuit voltage (OCV) of the cell in 97%H2 + 3%H2O/air was ~ 0.87 V and the maximum power density was ~ 270 mW/cm2 at 600 °C. The result shows that the high performance is achievable for the micro-SOFCs using a thick-film ceria-electrolyte operating at 600 °C.