Adsorption of bovine serum albumin at the air/water interface and its effect on the formation of DPPC surface film

The adsorption of bovine serum albumin (BSA) at the air/water interface and its effect on the transport of dipalmitoylphosphatidylcholine (DPPC) to form a surface film were studied with tensiometry, infrared reflection absorption spectroscopy (IRRAS), and ellipsometry. For 1, 10, 100, and 1000 ppm BSA solutions, the steady-state tension ranges from 55 to 50 mN m−1. At pulsating area (at 20 cycles min−1), both the minimum and maximum tensions decrease with increasing bulk concentration. Even though the steady-state tension is similar for 100 and 1000 ppm BSA, IRRAS and ellipsometry results indicate that the adsorbed density is higher for 1000 ppm BSA. For 1000 ppm/1000 ppm BSA/DPPC mixture, the tension behavior was found to be similar to that of 1000 ppm BSA when alone. Results from IRRAS and ellipsometry also demonstrate that BSA is the dominant adsorbed component at the air/water interface. Thus, at 1000 ppm, by adsorbing fast and possibly irreversibly, BSA interferes with the transport and adsorption of DPPC and inhibits its ability to lower the surface tension. However, when DPPC is introduced via a spread monolayer mechanism, DPPC expels partly or completely the adsorbed BSA monolayer and then controls the tension behavior with little or no inhibition by BSA. Thus, the competitive adsorption of DPPC and BSA depends strongly on the path or mechanism of introducing DPPC to the surface and involves path-dependent nonequilibrium adsorption phenomena.